IM6 – EXTRACORONAL ADJUSTABLE ANGULAR ATTACHMENT

Info

  • Dimensions

    Height: mm 3,7 – Width: mm 3,4 – Length: mm 5,4.

  • Male

    Ceramic alloy AU/600/ PT250/PD150.
    Melting point 1352-1492 °C.
    or patrix castable (plastic).

  • Female

    Stainless steel alloy AISI 316L.
    Melting point 1302-1329 °C.

  • WL block

    Biocompatible plastic.
    Resistant to 60 °C.

  • Screw

    Stainless steel alloy AISI 316L.

Use Indications

Remove the male from the female.
Position the male on the alveolar crest using the parallelometer mandrel, choose a direction which makes the insertion of the prosthesis easier. Join the male to the crown using adhesive wax, leaving a space of approx. 0.3 mm from the alveolar crest.
Insert the female into the male soldered to the crown, leaving a space of 0.2 mm from the female protection. Remove the screw and WL block from the female part and solder or glue it to the frame prosthesis.
Recommended solders for female: 890-920 °C. For male (ceramic) 1039-1100 °C, (resin) 750 °C or above.
Surfusion techniques may be used with wax models.
Pickle using 10% hot sulphuric acid or salts.
Adjust the retaining force using the screw (max 1/4 rotation).
Seal the opening on the screw using wax and cover with self-polymerising resin.
Do not reduce the dimensions of the attachment.

Maintenance

Check the base of the prosthesis every 12 months.
If necessary replace the WL block.

Warnings

The product is to be used by qualified dental technicians only, the same assume responsiblity for any risks arising from incorrect use.
Contains no dangerous substances. CR and NI not dangerous in steel alloy.
Do not use the device if the patient is allergic to the materials it contains.
Use safety goggles, masks, gloves and lab coats to prevent contact with dust and fumes, thereby eliminating all risks.
IM6 is designed for use on one prosthesis only.

The Components IM6

Parallelometer Mandrel